Fortinet black logo

CLI Reference

config firewall qos-filter6

config firewall qos-filter6

Use this command to configure QoS rules for IPv6 addresses.

A QoS filter is the policy that assigns traffic to the QoS queue.

Note: The QoS policy feature is not supported for traffic to virtual servers.

Before you begin:

  • You must have a good understanding and knowledge of traffic in your network that requires QoS provisioning.
  • You must have created the address configuration objects and service configuration objects that define the matching tuple for QoS rules.
  • You must have created a QoS queue configuration object.
  • You must have read-write permission for firewall settings.

Syntax

config firewall qos-filter6

edit <name>

set destination-address6 <datasource>

set in-interface <datasource>

set out-interface <datasource>

set queue <datasource>

set service <datasource>

set source-address6 <datasource>

set status {enable|disable}

next

end

destination-address6

Destination address object to use to form the matching tuple.

in-interface

Interface that receives traffic.

out-interface

Interface that forwards traffic.

queue

QoS queue that will be used for packets that match the filter criteria.

service

Service object to use to form the matching tuple.

source-address6

Source address object to use to form the matching tuple.

status

Enable/disable the filter.

config firewall qos-filter6

Use this command to configure QoS rules for IPv6 addresses.

A QoS filter is the policy that assigns traffic to the QoS queue.

Note: The QoS policy feature is not supported for traffic to virtual servers.

Before you begin:

  • You must have a good understanding and knowledge of traffic in your network that requires QoS provisioning.
  • You must have created the address configuration objects and service configuration objects that define the matching tuple for QoS rules.
  • You must have created a QoS queue configuration object.
  • You must have read-write permission for firewall settings.

Syntax

config firewall qos-filter6

edit <name>

set destination-address6 <datasource>

set in-interface <datasource>

set out-interface <datasource>

set queue <datasource>

set service <datasource>

set source-address6 <datasource>

set status {enable|disable}

next

end

destination-address6

Destination address object to use to form the matching tuple.

in-interface

Interface that receives traffic.

out-interface

Interface that forwards traffic.

queue

QoS queue that will be used for packets that match the filter criteria.

service

Service object to use to form the matching tuple.

source-address6

Source address object to use to form the matching tuple.

status

Enable/disable the filter.