Fortinet Document Library

Version:

Version:

Version:

Version:

Version:

Version:


Table of Contents

CLI Reference

config system address6

Use this command to create the IPv6 address objects that you use in firewall rules.

You create address objects to specify matching source and destination addresses in policies.

The following policies use address objects:

  • Connection limit policies
  • Firewall policies
  • Link Load Balance policies
  • QoS policies
Basic Steps
  1. Create address objects.
  2. Specify them when you configure your policies.

Before you begin:

  • You must have read-write permission for system settings.

Syntax

config system address6

edit <No.>

set type {ip6-network | ip6-range}

set ip6-network <ip&netmask>

set ip6-min <class_ip>

set ip6-max <class_ip>

next

end

type

  • ip6-network: address block
  • ip6-range: address range

ip6-network

Specify a subnet using the address/mask notation.

ip6-min

Specify the start of an address range.

ip6-max

Specify the end of an address range.

Example

FortiADC-docs # config system address6

FortiADC-docs (address6) # edit WAN

Add new entry 'WAN' for node 3811

FortiADC-docs (WAN) # set ip6-network 2001:DB8::/32

FortiADC-docs (WAN) # end

config system address6

Use this command to create the IPv6 address objects that you use in firewall rules.

You create address objects to specify matching source and destination addresses in policies.

The following policies use address objects:

  • Connection limit policies
  • Firewall policies
  • Link Load Balance policies
  • QoS policies
Basic Steps
  1. Create address objects.
  2. Specify them when you configure your policies.

Before you begin:

  • You must have read-write permission for system settings.

Syntax

config system address6

edit <No.>

set type {ip6-network | ip6-range}

set ip6-network <ip&netmask>

set ip6-min <class_ip>

set ip6-max <class_ip>

next

end

type

  • ip6-network: address block
  • ip6-range: address range

ip6-network

Specify a subnet using the address/mask notation.

ip6-min

Specify the start of an address range.

ip6-max

Specify the end of an address range.

Example

FortiADC-docs # config system address6

FortiADC-docs (address6) # edit WAN

Add new entry 'WAN' for node 3811

FortiADC-docs (WAN) # set ip6-network 2001:DB8::/32

FortiADC-docs (WAN) # end