Enabling GUI access
To enable GUI access to the FortiAnalyzer VM, you must configure the IP address and network mask of the appropriate port on the FortiAnalyzer VM. The following instructions use port 1.
The appropriate port can be determined by matching the MAC address of the network adapter and the |
To configure the port1 IP address and netmask:
- In your hypervisor manager, start the FortiAnalyzer VM and access the console window. You might need to press Enter to see the login prompt.
- At the FortiAnalyzer VM login prompt, enter the username admin, then press Enter. By default, there is no password.
- Using CLI commands, configure the port1 IP address and netmask.
config system interface
edit port1
set ip <IP address> <netmask>
end
The port management interface should match the first network adapter and virtual switch that you have configured in the hypervisor virtual machine settings.
- To configure the default gateway, enter the following commands:
config system route
edit 1
set device port1
set gateway <gateway_ipv4_address>
end