Fortinet Document Library

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:


Table of Contents

Administration Guide

Adding devices using the wizard

You can add devices and VDOMs to FortiAnalyzer using the Add Device wizard. When the wizard finishes, the device is added to the FortiAnalyzer unit, registered, and is ready to start sending logs.

To add devices using the wizard:
  1. If using ADOMs, ensure that you are in the correct ADOM.
  2. Go to Device Manager and click Add Device.

  3. Configure the following settings:

    IP Address

    Type the IP address for the device.

    SN

    Type the serial number for the device.

    Device Name

    Type a name for the device.

    Device Model

    Select the model of the device.

    Firmware Version

    Select the firmware version of the device.

    Description

    Type a description of the device (optional).

  4. Click Next.

    The device is added to the ADOM and, if successful, is ready to begin sending logs to the FortiAnalyzer unit.

  5. Click Finish to finish adding the device and close the wizard.

Adding devices using the wizard

You can add devices and VDOMs to FortiAnalyzer using the Add Device wizard. When the wizard finishes, the device is added to the FortiAnalyzer unit, registered, and is ready to start sending logs.

To add devices using the wizard:
  1. If using ADOMs, ensure that you are in the correct ADOM.
  2. Go to Device Manager and click Add Device.

  3. Configure the following settings:

    IP Address

    Type the IP address for the device.

    SN

    Type the serial number for the device.

    Device Name

    Type a name for the device.

    Device Model

    Select the model of the device.

    Firmware Version

    Select the firmware version of the device.

    Description

    Type a description of the device (optional).

  4. Click Next.

    The device is added to the ADOM and, if successful, is ready to begin sending logs to the FortiAnalyzer unit.

  5. Click Finish to finish adding the device and close the wizard.