Fortinet black logo

Session-Aware Load Balancing Cluster Guide

Changing FortiController-5103B interface speeds

5.2.10
Copy Link
Copy Doc ID 31a89d05-200d-11e9-b6f6-f8bc1258b856:29384
Download PDF

Changing FortiController-5103B interface speeds

To change front panel B1 and B2 interface speeds, from the FortiController-5103B GUI go to Switch > Base Channel and edit the b1 or b2 interface. Set the Speed to 10Gbps Full-duplex or 1Gpbs Full duplex and select OK. From the CLI enter the following command to change the speed of the B1 port.

config switch base-channel physical-port

edit b1

set speed {10000full | 1000full}

end

To change front panel F1 to F8 interface speeds, from the FortiController-5103B GUI go to Switch > Fabric Channel and edit a f1 to f8 interface. Set the Speed to 10Gbps Full-duplex or 1Gpbs Full duplex and select OK. From the CLI enter the following command to change the speed of the F6 port.

config switch fabric-channel physical-port

edit f6

set speed {10000full | 1000full}

end

To change backplane fabric channel interface speeds, from the FortiController-5103B GUI go to Switch > Fabric Channel and edit a slot-1/2 to slot 14 interface. Set the Speed to 10Gbps Full-duplex or 1Gpbs Full duplex and select OK. From the CLI enter the following command to change the speed of the slot-4 port.

config switch fabric-channel physical-port

edit slot-4

set speed {10000full | 1000full}

end

Changing FortiController-5103B interface speeds

To change front panel B1 and B2 interface speeds, from the FortiController-5103B GUI go to Switch > Base Channel and edit the b1 or b2 interface. Set the Speed to 10Gbps Full-duplex or 1Gpbs Full duplex and select OK. From the CLI enter the following command to change the speed of the B1 port.

config switch base-channel physical-port

edit b1

set speed {10000full | 1000full}

end

To change front panel F1 to F8 interface speeds, from the FortiController-5103B GUI go to Switch > Fabric Channel and edit a f1 to f8 interface. Set the Speed to 10Gbps Full-duplex or 1Gpbs Full duplex and select OK. From the CLI enter the following command to change the speed of the F6 port.

config switch fabric-channel physical-port

edit f6

set speed {10000full | 1000full}

end

To change backplane fabric channel interface speeds, from the FortiController-5103B GUI go to Switch > Fabric Channel and edit a slot-1/2 to slot 14 interface. Set the Speed to 10Gbps Full-duplex or 1Gpbs Full duplex and select OK. From the CLI enter the following command to change the speed of the slot-4 port.

config switch fabric-channel physical-port

edit slot-4

set speed {10000full | 1000full}

end