Fortinet Document Library

Version:


Table of Contents

1.0.1
Download PDF
Copy Link

Connect to the GUI

The FortiDeceptor unit is configured and managed using the GUI. This section will step you through connecting to the unit via the GUI.

To connect to the FortiDeceptor GUI:
  1. Connect the port1 (administration) interface of the device to a management computer using the provided Ethernet cable.
  2. Configure the management computer to be on the same subnet as the internal interface of the FortiDeceptor unit:
    1. Change the IP address of the management computer to 192.168.0.2 and the network mask to 255.255.255.0.
  3. Start a supported web browser and browse to https://192.168.0.99.
  4. Type admin in the Name field, leave the Password field blank, and select Login.

    You can now proceed with configuring your FortiDeceptor unit.

If the network interfaces have been configured differently during installation, the URL and/or permitted administrative access protocols may no longer be in their default state.

Connect to the GUI

The FortiDeceptor unit is configured and managed using the GUI. This section will step you through connecting to the unit via the GUI.

To connect to the FortiDeceptor GUI:
  1. Connect the port1 (administration) interface of the device to a management computer using the provided Ethernet cable.
  2. Configure the management computer to be on the same subnet as the internal interface of the FortiDeceptor unit:
    1. Change the IP address of the management computer to 192.168.0.2 and the network mask to 255.255.255.0.
  3. Start a supported web browser and browse to https://192.168.0.99.
  4. Type admin in the Name field, leave the Password field blank, and select Login.

    You can now proceed with configuring your FortiDeceptor unit.

If the network interfaces have been configured differently during installation, the URL and/or permitted administrative access protocols may no longer be in their default state.