When FortiAnalyzer logging is configured using an FQDN domain, the GUI displays a 500 error message on the FortiView Compromised Hosts page.

AntiVirus archive logging enabled from the CLI will be disabled by editing the AntiVirus profile in the GUI, even if no changes are made.

Inconsistent reference count when using ports in HA session-sync-dev.

When creating an antispam block/allow list entry, Mark as Reject should be grayed out.

Log viewer forwarded traffic does not support multiple filters for one field.

OK button missing from many pages when viewed in Chrome on an Android device.

VPN event logs shows incorrectly when adding two Action filters and one of them contains "-".

Warning message is not displayed when a user configures an interface with a static IP address that is already in use.

Managed FortiSwitch and FortiSwitch Ports pages are slow to load when there are many managed FortiSwitches.

When creating or editing an IPv4 policy or address group, firewall address searching does not work if there is an empty wildcard address due to a configuration error.

Intermittent GUI process crash if a managed FortiSwitch returns a reset status.

Some GUI pages (dashboard, topology, policy list, interface list) are slow to load on low-end platforms when there are many concurrent HTTPSD requests.

GUI incorrectly displays the warning, Botnet package update unavailable, AntiVirus subscription not found., when the antivirus entitlement is expiring within 30 days. The actual botnet package update still works within the active entitlement duration.

After performing a search on firewall Addresses, the matched count over total count displayed for each address type shows an incorrect total count number. The search functionality still works correctly.

The Edit Web Filter Profile page incorrectly shows that a URL filter is configured (even though it is not) if the URL filter entry has the same name as the web filter profile in the CLI.

On some browser versions, the GUI displays a blank dialog when creating custom application or IPS signatures. Affected browsers: Firefox 85.0, Microsoft Edge 88.0, and Chrome 88.0.

When logs are retrieved from FortiAnalyzer, the GUI displays the same traffic logs for primary and secondary HA devices.

Secondary device failed to sync with primary device when FGSP is peer configured, but hasync fails to bind socket.

Cluster is out of sync because of config vpn certificate ca after upgrade.

IPS engine 5.00027 has signal 11 crash.

IPS intelligent mode not working when reflect sessions are created on different physical interfaces.

IPS engine 5.00035 has signal 11 crash.

When IPS pcap is enabled, traffic is intermittently disrupted after disk I/O reaches IOPS limit.

On FG-80D, the IPS engine daemon count drops to 0 when the CPU number is 4.

IPS is constantly crashing, and ipshelper has high CPU when IPS extended database has too many rules (more than 256) sharing the same pattern. Affected models: SoC3-based FortiGates.

Workaround: disable CP or disable the extended database.

config ips global
    set database regular
    set cp-accel-mode none
end

When an offloaded IPsec SA uses NP6 reserved space, it gets stuck and packets on the tunnel start to drop.

Static routes added by iked in non-root VDOM are not removed when tunnel interface status is set to down by configuration change.

Unable to route traffic to a spoke VPN site from the hub FortiGate when the dialup IPsec VPN interface is dual stacked (IPv4/IPv6).

Packets for the existing session are still forwarded via the old tunnel after the routing changed on the ADVPN hub.

User observes FGT internal error while trying to log in or activate FortiGate Cloud from the web UI.

BFD/BGP dropping when outbandwidth is set on interface.

SD-WAN IPv6 route tag command is not available in the SD-WAN services.

SD-WAN rule disappears when an SD-WAN member experiences a dynamic change, such as during a dynamic PPPoE interface update.

Possible memory leak when BGP table version increases.

Router daemons get stuck after rebooting when executing get router info routing-table all.

FortiGate as first hop router sometimes does not send register messages to the RP.

Slow GUI performance in large Fabric topology with over 50 downstream devices.

FortiNAC requests to FortiGate can timeout on low-end models when there are many concurrent requests.

WALLIX Manager GUI interface is not loading through SSL VPN web mode.

Policy check cache should include user or group information.

Split tunneling is not adding FQDN addresses to the routes.

The jstor.org webpage is not loading via SSL VPN bookmark.

GUI should add support to allow using switch VLAN interface under a tenant VDOM on a managed switch VDOM.

If the firewall is downgraded from 6.2.3 to 6.2.2, the FortiLink interface looses its CAPWAP setting.

EHP drops for units with no NP service module.

FortiManager Cloud cannot be removed once the FortiGate has trouble on contract.

SNMP does not provide routing table for non-management VDOM.

Interface emac-vlan feature does not work on SoC4 platform.

factoryreset2 does not preserve all interfaces.

FortiGate in LENC mode unable to pass firmware signature verification and shows as uncertified after GUI upgrade.

ARM-based platforms do not have sensor readings included in SNMP MIBs.

The sflowd process has high CPU usage when application control is enabled.

Offloaded traffic from IPsec crossing the NPU VDOM link is dropped.

High CPU on L2TP process caused by loop.

confsyncd may crash when there is an error parsing through the internet service database, but no error is returned.

When a VRF is used on SoC4 platforms, nTurbo traffic is wrongly categorized as GTPU.

stpforward does not work with LAG interfaces on a transparent VDOM.

Unable to reorder firewall DoS policy in GUI or CLI.

Device identification via LLDP on an aggregate interface does not work.

Cannot select remote certificate imported from CLI for SAML IdP.

FG-VM image unable to be deployed on AWS with additional HDD (st1) disk type.

Azure SDN connector replicates configuration from primary device to secondary device during configuration restore.

FG-VM-GCP reboots a couple of times due to kernel panic.

IPsec VPN tunnel not staying up after failing over with AWS A-P cross-AZ setup.

Spoke dialup IPsec VPN does not initiate connection to hub after FG-VM HA failover in Azure.

FortiGate AWS bootstrapped from configuration does not read SAML settings.

Dialup IPsec tunnel from Azure may not be re-established after HA failover.

HTTPS administrative interface responds over heartbeat port on Azure FortiGate despite allowaccess settings.

In the CLI, the WTP profile for radio-2 802.11ac and 80 MHz channels does not match the syntax collection files.