Fortinet black logo

Administration Guide

Home FortiIsolator 1.2.1 Administration Guide

Configuring routing settings

1.2.1
2.4.4
2.4.3
2.4.2
2.4.1
2.4.0
2.3.4
2.3.1
2.3.0
2.2.0
2.1.2
2.1.1
2.1.0
2.0.1
2.0.0
1.2.2
1.2.1
1.2.0
1.1.0
Copy Link
Copy Doc ID ff7385cb-a8b9-11e9-81a4-00505692583a:672569
Download PDF

Configuring routing settings

Use this procedure to configure routing settings for FortiIsolator.

Adding a static route

Use this procedure to add a static route.

Steps
  1. In the FortiIsolator UI, go to Network > System Routing.
  2. To add a new static route, click Create New.
  3. Type the destination IP address and subnet mask in the Destination IP/Mask field.
  4. Type the gateway IP address in the Gateway field.
  5. In the Device drop-down list, select the interface for the static route.
  6. Click OK.

Editing a static route

Use this procedure to edit a static route.

Steps
  1. In the FortiIsolator UI, go to Network > System Routing.
  2. To edit an existing static route, select the interface in the table, and click Edit.
  3. Type the destination IP address and subnet mask in the Destination IP/Mask field.
  4. Type the gateway IP address in the Gateway field.
  5. In the Device drop-down list, select the interface for the static route.
  6. Click OK.

Deleting a static route

Use this procedure to delete a static route.

Steps
  1. In the FortiIsolator UI, go to Network > System Routing.
  2. To delete a static route, select the interface in the table, and click Delete.

The following image shows an example of the System Routing page.

Previous
Next

Configuring routing settings

Use this procedure to configure routing settings for FortiIsolator.

Adding a static route

Use this procedure to add a static route.

Steps
  1. In the FortiIsolator UI, go to Network > System Routing.
  2. To add a new static route, click Create New.
  3. Type the destination IP address and subnet mask in the Destination IP/Mask field.
  4. Type the gateway IP address in the Gateway field.
  5. In the Device drop-down list, select the interface for the static route.
  6. Click OK.

Editing a static route

Use this procedure to edit a static route.

Steps
  1. In the FortiIsolator UI, go to Network > System Routing.
  2. To edit an existing static route, select the interface in the table, and click Edit.
  3. Type the destination IP address and subnet mask in the Destination IP/Mask field.
  4. Type the gateway IP address in the Gateway field.
  5. In the Device drop-down list, select the interface for the static route.
  6. Click OK.

Deleting a static route

Use this procedure to delete a static route.

Steps
  1. In the FortiIsolator UI, go to Network > System Routing.
  2. To delete a static route, select the interface in the table, and click Delete.

The following image shows an example of the System Routing page.

Previous
Next