Configuring interface settings
Use this procedure to configure FortiIsolator interface settings.
Steps
- In the FortiIsolator UI, go to Network > Interfaces.
- To edit an interface, select the interface in the table, and click Edit.
- To change the interface status, set the Interface Status field to one of the following options:
- To turn on the interface, click Link Up .
- To turn off the interface, click Link Down .
- To change the IP address of the interface, enter an IP address and netmask in the IPv4 field.
- Click OK.
The following image shows an example of the FortiIsolator Interfaces page.