FortiSwitch profiles
If SD-WAN Orchestrator MEA prompts an exception when changing the profile of a device as reported in issue 064530, check if the two profiles meet the following conditions:
- Compare VLANs in interface FortiLink with these two profiles, and check if there are VLANs that own same VLAN ID.
- Compare VLANs in same interface (except interface FortiLink) with these two profiles, and check if there are VLANs that own same name, but have different VLAN IDs.
- Compare VLANs in different interfaces (except interface FortiLink) with these two profiles, and check if there are VLANs that own same name.
Workaround:
- Make sure the device is synchronized, and then enable the override device LAN setting.
- Release resources (for example, IP pool, DHCP server, and so on) used by VLANs (except default, video, voice, rspan, onboarding, quarantine) in interface FortiLink.
- Release resources used by VLANs that meet condition 2 above, and then delete these VLANs.
- Release resources used by VLANs that meet condition 3 above, and then delete these VLANs.
- Disable Switch/AP configuration in Device LAN setting page.
- Wait 5-10 minutes until device’s configuration state becomes Modified, and then trigger a manual deployment.
- When device is synchronized, change profile.
- After changing the profile, disable override device LAN setting.