Fortinet Document Library

Version:

Version:

Version:

Version:

Version:


Table of Contents

Administration Guide

Configure IP addresses on an aggregate interface

To configure IP addresses on an aggregate interface using the GUI:
  1. Go to System > Interfaces and click Create New.

  2. Select the Interface Members and set up the IPv4 address and netmask.
  3. Click OK.

    A new interface called bond1 is created.

To configure IP addresses on an aggregate interface using the CLI:
  1. Use the show command to display information about all interfaces.
  2. Enter the following command.
    hc-settings  -si –ibond1 –a<External IP/NetMask>
  3. Enter the show command again to see the new external IP address.

    In the GUI, System > Interfaces also displays the new external IP address.

Configure IP addresses on an aggregate interface

To configure IP addresses on an aggregate interface using the GUI:
  1. Go to System > Interfaces and click Create New.

  2. Select the Interface Members and set up the IPv4 address and netmask.
  3. Click OK.

    A new interface called bond1 is created.

To configure IP addresses on an aggregate interface using the CLI:
  1. Use the show command to display information about all interfaces.
  2. Enter the following command.
    hc-settings  -si –ibond1 –a<External IP/NetMask>
  3. Enter the show command again to see the new external IP address.

    In the GUI, System > Interfaces also displays the new external IP address.