This example shows a FortiLink scenario where the FortiGate acts as the switch controller that collects the data statistics of managed FortiSwitch ports. This is counted by each FortiSwitch and concentrated in the controller.
- Go to WiFi & Switch Controller > FortiSwitch Ports.
- Select Configure Table.
- Select Bytes, Errors and Packets to make them visible.
The related data statistic of each managed FortiSwitch port is shown.
# diagnose switch-controller switch-info port-stats S248EPTF180XXXX ...... Port(port50) is Admin up, line protocol is down Interface Type is Gigabit Media Independent Interface(GMII) Address is 70:4C:A5:E0:F3:8D, loopback is not set MTU 9216 bytes, Encapsulation IEEE 802.3/Ethernet-II full-duplex, 1000 Mb/s, link type is manual input : 0 bytes, 0 packets, 0 errors, 0 drops, 0 oversizes 0 unicasts, 0 multicasts, 0 broadcasts, 0 unknowns output : 0 bytes, 0 packets, 0 errors, 0 drops, 0 oversizes 0 unicasts, 0 multicasts, 0 broadcasts 0 fragments, 0 undersizes, 0 collisions, 0 jabbers ......