Configure the site1_mclag2 switch
Follow these steps on the site1_mclag2 FortiSwitch unit in the MCLAG peer group:
- Enable FortiLink mode.
config system global
set switch-mgmt-mode fortilink
end
- Set the switch-controller discovery type to DHCP.
config switch-controller global
set ac-discovery-type dhcp
end
- FortiLink over layer 3 is not enabled on the switch interface connected to the WAN router. NOTE: The FortiGate device can already be reached using the inter-switch link (ISL) formed with the site1_mclag1 FortiSwitch unit.
config switch interface
edit "8DVHFUKEFGG54-0"
set native-vlan 4094
set allowed-vlans 1
set dhcp-snooping trusted
set edge-port disabled
set snmp-index 12
next
end