Resetting the configuration
If you will be selling your FortiWeb appliance, or if you are not sure what part of your configuration is causing a problem, you can reset it to its default settings and erase data. If you have not updated the firmware, this is the same as resetting to the factory default settings.
|Back up your configuration before beginning this procedure, if possible. Resetting the configuration could include the IP addresses of network interfaces. For details about backups, see Backup & restore. For details about reconnecting to a FortiWeb appliance whose network interface configuration was reset, see Connecting to the web UI or CLI.|
To delete your data from the appliance, connect to the CLI and enter this command:
To reset the appliance’s configuration, connect to the CLI and enter this command:
|Alternatively, you can reset the appliance’s configuration to its default values for a specific software version by restoring the firmware during a reboot (a “clean install”). For details, see Restoring firmware (“clean install”).|