Synchronizing FortiClient EMS tags and configurations

A new option under the FortiClient EMS settings consolidates the setup of EMS connectors to support EMS tags. EMS tags are pulled and automatically synced with the EMS server. They are converted into read-only dynamic firewall addresses that can be used in firewall policies, routing, and so on.

These examples presume the following have been configured in FortiClient EMS:

• Tags have been created on the Compliance Verification > Compliance Verification Rules page.

  

• There are registered users who match the defined tags that are visible on the Compliance Verification > Host Tag Monitor page.

  

To configure FortiClient EMS with tag synchronization in the GUI:

1. Configure the EMS Fabric Connector:
   1. On the root FortiGate, go to Security Fabric > Fabric Connectors.
   2. Click Create New and click FortiClient EMS.
   3. Enable Synchronize firewall addresses.

      

   4. Configure the other settings as needed and validate the certificate.
   5. Click OK.
2. Go to Policy & Objects > Addresses and hover over the EMS tag to view which IPs it resolves to.
3. Configure a firewall policy:
   1. Go to Policy & Objects > Firewall Policy and create a new policy.
   2. For the Source Address, add the EMS tag dynamic address.

      

   3. Configure the other settings as needed.
   4. Click OK.

To configure FortiClient EMS with tag synchronization in the CLI:

1. Configure the EMS Fabric Connector:

   config endpoint-control fctems
       edit "ems137"
           set fortinetone-cloud-authentication disable
           set server "172.16.200.137"
           set https-port 443
           set source-ip 0.0.0.0
           set pull-sysinfo enable
           set pull-vulnerabilities enable
           set pull-avatars enable
           set pull-tags enable
           set call-timeout 5000
           set certificate "REMOTE_Cert_1"
       next
   end

2. Verify which IPs the dynamic firewall address resolves to:

   # diagnose firewall dynamic list 
   List all dynamic addresses:
   FCTEMS0580226579_ems137_vuln_critical_tag: ID(118)
           ADDR(10.1.100.120)
           ADDR(10.1.100.198)
   
   FCTEMS0580226579_ems137_winscp_tag: ID(155)
           ADDR(100.100.100.141)
   
   FCTEMS0580226579_ems137_win10_tag: ID(182)
           ADDR(10.1.100.120)

   # diagnose firewall dynamic address FCTEMS0580226579_ems137_vuln_critical_tag
   FCTEMS0580226579_ems137_vuln_critical_tag: ID(118)
           ADDR(10.1.100.120)
           ADDR(10.1.100.198)
   
   Total dynamic list entries: 1.
   Total dynamic addresses: 2
   Total dynamic ranges: 0

3. Configure a firewall policy that uses the EMS tag dynamic firewall address as a source.