Adding a static route

You must configure a default route for the SD-WAN. The default gateways for each SD-WAN member interface do not need to be defined in the static routes table. FortiGate will decide what route or routes are preferred using Equal Cost Multi-Path (ECMP) based on distance and priority.

To create a static route for SD-WAN:

1. Go to Network > Static Routes.
2. Click Create New. The New Static Route page opens.
3. Set Destination to Subnet, and leave the IP address and subnet mask as 0.0.0.0/0.0.0.0.
4. From the Interface drop-down list, select SD-WAN.

   

5. Ensure that Status is Enabled.
6. Click OK.

Next: Selecting the implicit SD-WAN algorithm