Synchronizing sessions between FGCP clusters

Synchronizing sessions between FGCP clusters is useful when data centers in different locations are used for load balancing, and traffic must be shared and flow freely based on demand.

There are some limitations when synchronizing sessions between FGCP clusters:

• All FortiGates must have the same model and generation, hardware configuration, and FortiOS version.
• A total of 16 clusters can share sessions.

• The configurations related to session tables should match. For example, the logical names used in firewall policies, IPsec interface names, VDOM names, firewall policy tables, and so on.

To configure session synchronization between two clusters:

1. Configure the two clusters (see HA active-passive cluster setup or HA active-active cluster setup).
2. On cluster A, configure the peer IP for the interface:

   config system interface
       edit "port5"
           set vdom "root"
           set ip 10.10.10.1 255.255.255.0
           set allowaccess ping https ssh snmp http telnet
       next
   end

   In this example, cluster A uses port5 and its IP address, 10.10.10.1, is reachable from another cluster.

3. On cluster A, configure FGSP, including cluster and session synchronization:

   config system standalone-cluster
       set standalone-group-id 1
       set group-member-id 0
       set session-sync-dev <interface>
       config cluster-peer
           edit 1
               set peerip 10.10.10.2
           next
       end
   end

   The standalone-group-id must match between FGSP members. The group-member-id is unique for each FGCP cluster. session-sync-dev is an optional command to specify the interfaces to sync sessions.

4. On cluster B, configure the peer IP for the interface:

   config system interface
       edit "port5"
           set vdom "root"
           set ip 10.10.10.2 255.255.255.0
           set allowaccess ping https ssh snmp http telnet
       next
   end

   In this example, cluster B uses port5 and its IP address, 10.10.10.2, is reachable from another cluster.

5. On cluster B, configure FGSP, including cluster and session synchronization:

   config system standalone-cluster
       set standalone-group-id 1
       set group-member-id 1
       set session-sync-dev <interface>
       config cluster-peer
           edit 1
               set peerip 10.10.10.1
           next
       end
   end