Security Fabric connectors
This section contains information about how to configure the following devices as part of the Fortinet Security Fabric:
- Configuring the root FortiGate and downstream FortiGates
- Configuring logging and analytics
- Configuring FortiClient EMS
- Synchronizing FortiClient ZTNA tags
- Configuring LAN edge devices
- Configuring central management
- Configuring sandboxing
- Configuring supported connectors
System requirements
To set up the Security Fabric, the devices that you want to include must meet the Product Integration and Support requirements in the FortiOS Release Notes.
Some features of the Security Fabric are only available in certain firmware versions and models. Not all FortiGate models can run the FortiGuard Surface Attack Security Rating Service if they are the root FortiGate in a Security Fabric. For more information, see the Special Notices in the FortiOS Release Notes.
Prerequisites
- If devices are not already installed in your network, complete basic installation and configuration tasks by following the instructions in the device documentation.
- FortiGate devices must be operating in NAT mode.