Installing FortiIsolator VM for Microsoft Hyper-V
Use this procedure to install FortiIsolator VM for Microsoft Hyper-V.
Prerequisites
Install Microsoft Hyper-V Manager.
Steps
- Download the FortiIsolator firmware for Hyper-V by following the instructions in Downloading FortiIsolator firmware.
- Unzip the downloaded .zip file to get “isolator.vhd” image.
- To create a new virtual machine, launch Hyper-V Manager, connect to Server from Hyper-V Manager, then right clicking on Server to create New Virtual Machine.
- In New Virtual Machine Wizard: Next.
- Specify Name and Location: provide a name for the new FortiIsolator VM, then Next.
- Specify Generation: select Generation 1, then Next.
- Assign Memory: allocate sufficient RAM on to FortiIsolator.
- Make sure there is sufficient RAM allocated to the VM. This can be checked in Windows 10 through Task Manager > Performance > Memory > Available.
- It’s recommended to allocate a minimum of 16GB (16384 MB) of RAM to FIS VM for supporting 50 sessions or more.
- Configure Networking:
Connection: NAT
- Connect Virtual Hard Disk:
Use an existing virtual hard disk:
isolator.vhd
.
- Completing the New Virtual Machine Wizard: Finish.
- After the new Virtual Machines is created and displays under Virtual Machines panel, right click on it and go to Settings.
- To add new hard drive for FortiIsolator, from Settings wizard, select IDE Controller 0, select Hard Drive, then Add.
- Under Media, select Virtual hard disk > New.
- Go to Before You Begin > Next.
Choose Disk Format: VHD
Choose Disk Type: Fixed size
Specify Name and Location
- Configure Disk:
Create a new blank virtual disk (e.g. Size: 20 GB)
- Summary of New Virtual Hard Disk:
- In Settings wizard, Apply to save the settings.
- Follow these steps to add three new Network Adapters for FortiIsolator.
- Select Add Hardware > Network Adapter > Add.
- Virtual switch > VMnet1 > Apply.
- Repeat the last two steps to add two more Network Adapter:
Network Adapter: VMnet 2
Network Adapter: VMnet 3
- Summary of Network Adapter:
Network Adapter: NAT (for FIS Internal port)
Network Adapter: VMnet 1 (for FIS External port)
Network Adapter: VMnet 2 (for FIS Management port)
Network Adapter: VMnet 3 (for FIS HA port)
- Click Apply to save the setting and exit back to Virtual Machines Wizard.
- Right-click FIS VM and connect to start.
- Log in to FortiIsolator. The default username is
admin
and there is no default password.