system admin
Use this command to configure FortiMail administrator accounts.
By default, FortiMail units have a single administrator account, admin
. For more granular control over administrative access, you can create additional administrator accounts that are restricted to being able to configure a specific protected domain and/or with restricted permissions. For more information, see the FortiMail Administration Guide.
Syntax
config system admin
edit <name_str>
set access-profile <profile_name>
set auth-strategy {cloud | ldap | local | pki | radius | sso}
set level {domain | domain-group | system}
set ldap-profile <profile_name>
set radius-profile <profile_name>
set sshkey <key_str>
set sso-profile <profile_name>
set theme {Blue |Green | Light-Blue | Red}
set trusted-hosts <host_ipv4mask>
set webmode {advanced | cloud-api | simple}
end
Variable |
Description |
Default |
||
Enter the name of the administrator account. |
|
|||
Enable to activate the administrator account. |
disable |
|||
Select the access method allowed for the administrator. Access methods require that you also enabled the associated protocols on the network interface where the administrator connects. |
cli gui rest |
|||
Enter the name of an access profile that determines which functional areas the administrator account is allowed to view or affect. |
|
|||
Select the type of authentication profile that the administrator account will use to log in. (The If you did not select
|
local |
|||
Enter this administrator account’s preference for the display language of the GUI. Available languages vary by whether or not you have installed additional language resource files. To view a list of languages, enter a question mark ( |
english |
|||
Select the administrator's access level. |
system |
|||
If |
|
|||
If
|
|
|||
If |
|
|||
If |
|
|||
Enter the SSH public key string surrounded in single straight quotes ( When connecting from an SSH client that presents this key, the administrator will not need to provide their account name and password in order to log in to the CLI. |
|
|||
If |
|
|||
Enter this administrator account’s preference for the display theme when logging in. |
Green |
|||
Enter one to three IP addresses and netmasks from which the administrator can log in to the FortiMail unit. Separate each IP address and netmask pair with a comma ( To allow the administrator to authenticate from any IP address, enter |
0.0.0.0/0.0.0.0 |
|||
Enter which display mode will initially appear when the administrator logs in to the GUI. The administrator can switch the display mode during their session; this setting only affects the initial state of the display. |
simple |