Adding FortiAnalyzer devices using a fabric connection
To add a remote FortiAnalyzer using a fabric connection:
The following configuration is required in the FortiManager CLI before adding a FortiAnalyzer using a fabric connection:
config system csf
set status enable
set accept-auth-by-cert enable
set downstream-access enable
end
Under config system interface, the port's allowaccess setting includes fabric.
-
In the FortiAnalyzer, go to System Settings > Fabric Management > Fabric Connectors.
-
Select the FortiManager connector and click Edit.
Alternatively, you can double-click the connector, or right-click the connector and select Edit.
-
In the FortiManager IP/FQDN field, enter the IP of the FortiManager.
-
Toggle the Status to Enabled.
-
Click OK and wait for the connection.
-
Once the connection status is Pending Authorization, click Authorize.
-
In the authorization page, select the ADOM to add the FortiAnalyzer to and click Next.
-
After authorizing, the FortiAnalyzer is added to FortiManager under Device Manager > Device & Groups > Managed FortiAnalyzer.
Alternatively, you can authorize the FortiAnalyzer from the FortiManager GUI.
