Neighbors
You can create SD-WAN rules that include Border Gateway Protocol (BGP) neighbors.
You must create BGP neighbors for FortiGate devices before you can add them to SD-WAN templates.
To configure BGP neighbors for SD-WAN templates:
- If using ADOMs, ensure that you are in the correct ADOM.
-
Go to SD-WAN Manager > Rules .
- Double-click an SD-WAN template to open it for editing, or click Create New in the toolbar.
The SD-WAN template opens.
- In the Neighbor toolbar, click Create New.
The Create New SD-WAN Neighbor pane opens:
- Configure the following:
IP
Type the IP address for the BGP neighbor.
Interface Member
Click the box, and select interface members.
Multiple interface members can be selected for a neighbor. This allows the SD-WAN neighbor feature to support topologies where there are multiple SD-WAN overlays and/or underlays to a neighbor. When multiple interface members are selected, route failover will only occur if both tunnels to a neighbor are down.
Performance SLA
Click the list, and select the performance SLA.
Role
Select Standalone, Primary, or Secondary.
Installation Target
Choose installation targets.
Advanced Options
Expand to display the advanced options.
- Click OK.