Assigning access values and CLI configurations
You assign access values and CLI configurations to devices for each logical network, either by configuring a single device or configuring multiple devices at the same time.
Several default networks are shown as logical networks in the Model Configuration tab: Default, Registration, Quarantine, Dead End, Authentication, and Voice. These networks are configured as logical networks but do not appear in the Logical Networks tab.
Configuring a single device
- Go to Network Devices > Topology.
- Expand the container where the device is located.
- Click the device and click the Model Configuration tab.
- Under Access, use the drop-down list to set the access value for each logical network.
- (Optional) Set CLI Configuration Type to Port Based or Host Based. Under CLI, use the drop-down list to set the configuration for each logical network.
- Click Save.
Configuring multiple devices
- Go to Network Devices > Topology.
- Select the container where the devices is located.
- In the Devices tab, click the devices while pressing
Ctrl
. - Right-click the devices and click Set Model Configuration.
- Use the Add Configuration Category drop-down list to select a logical network.
- Select Access Value/VLAN and assign a value.
- (Optional) Select CLI Configuration Type, set type to Port Based or Host Based, and select a configuration.
- Click OK.