execute raidlevel
Use this command to reset the RAID level, partition the disk, and optionally encrypt the disk if supported.
|
Executing this command will erase all existing data on the RAID array. |
Syntax
execute raidlevel <raid-level-option> [encryption <security_key>]
|
Variable |
Description |
Default |
|---|---|---|
|
<raid-level-option> |
Enter a raid level, such as 1 or 10. Click Tab to show optional level values. |
|
|
[encryption <security_key>] |
Encrypt the disk and set the security key. Key value should be a combination of numbers, uppercase letters, lowercase letters, and selected special characters. Its length should be between 8 and 32. Selected special characters are ! # $ % * + , - . : = @ [ ] ^ - _ { } ~. Note: This option is only available in FNDR 1000F and FNDR 3600G. |
|
Support in FortiNDR 1000F
For FortiNDR 1000F, use the CLI command diagnose system raid-status-detail to verify if it supports the encryption feature. In the CLI output, you need to see:
Enterprise Key Management:
=========================
Capability = Supported
If this is not present, please contact Fortinet to obtain a hardware key to enable this feature.