Blocked hosts

If you enable blocked hosts as a global setting in General, the system enforces a configurable blocklist for all admin and users.

Configure blocked IP addresses in the Blocked Hosts tab.

The blocklist is a system level feature, and it applies to SSO and SAML users.

To create a blocked host:

1. Go to System > Settings > Blocked Hosts.

   Select a blocked host and then click Edit to edit the blocked host. When editing a blocked host, the fields are the same as those that appear when creating a blocked host.

2. In the Blocked Hosts tab, click Create.

   The Create Blocked Hosts window opens.

3. Enter the following information:

4. Field	Required	Description
   Type	Y	Select IPv4 or IPv6.
   IP Start	Y	Enter the start address for the range covered by this entry.
   Mask	Y	If Type is set to IPv4, define the range of IP addresses covered by this entry.
   Prefix	Y	If Type is set to IPv6, define the range of IP addresses covered by this entry.

5. Click Save.

To delete one or more blocked hosts, select the hosts and click Delete.