Enabling GUI access
To enable GUI access to the FortiSandbox VM, configure the port1 IP address and network mask of the FortiSandbox VM.
To configure the port1 IP address and netmask:
- In your hypervisor manager, start the FortiSandbox VM and access the console window. You might need to press Enter to see the login prompt.
- At the FortiSandbox VM login prompt, enter the username admin, then press Enter.
There is no password by default. The system will require you to set a password.
- Using CLI commands, configure the port1 IP address and netmask with the following command:
- Configure the static route for the default gateway with the following command:
set port1-ip <ip address>/<netmask>
set default-gw <default gateway>