Overview
You can configure some settings through a connection to the command-line interface (CLI).
This requires a terminal emulator such as PuTTY, TeraTerm, or a terminal server.
To connect to the CLI via a serial console:
- Use the console cable to connect the appliance console port to your terminal server or computer.
- On your computer or terminal server, start the terminal emulator. Use the following settings:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
- Press
Enter
on your keyboard to connect to the CLI.
After you configure the management port, you can connect to the management port and use the CLI remotely by SSH or Telnet. |