Interfaces

To view and manage interfaces, go to Network > Interfaces. All of the columns in the table are searchable and support custom filters.

This page displays the following information and options:

Interface		The interface name and description. Failover IP is listed under this field with the descriptor: (cluster external port).
	port1 (administration port)	Port1 is hard-coded as the administration interface. You can enable or disable HTTP, SSH, and Telnet access rights on port1. HTTPS is enabled by default and cannot be disabled. You can use port1 for Device mode although a different, dedicated port is recommended.
	port2	Decoy VM deployment.
	port3	Decoy VM deployment.
	port4	Decoy VM deployment.
	port5/port6	Decoy VM deployment.
	port7/port8	Decoy VM deployment.
IPv4		The IPv4 IP address and subnet mask of the interface.
IPv6		The IPv6 IP address and subnet mask of the interface.
Interface Status		The state of the interface: Interface up Interface down Interface is being used by sniffer
Link Status		The link status: Link up Link down
Access Rights		The access rights associated with the interface. HTTPS is enabled by default on port1. You can enable HTTP, SSH, and Telnet access on port1.
Edit		Select the interface and click Edit in the toolbar to edit the interface.

To filter the columns in the table:

1. Click the plus sign in the Search field. The Filterable Columns menu opens.

   

2. Select a column in the list to Resize to Contents, Group By This column or create a custom filter.

3. Click Apply.

To show or hide columns in the table:

1. Hover the header row until the Configure Table icon appears.

   

2. Click Configure Table. The Best Fit Columns menu opens.

3. Select the columns to appear in the table and click Apply.

4. To restore the default table, click Reset Table.

To edit an interface:

1. Select the IPv4 or IPv6 address of an interface name and click Edit in the toolbar.
2. Edit the IP Address / Netmask. The Confirmation dialog opens.
3. (Optional) Change the Interface Status.
4. In the IP Address / Netmask pane, update the IPv4 and IPv6 address.
5. Click OK.

To edit administrative access:

1. Select port1 (administration port) and click Edit in the toolbar.
2. Edit the Access Rights.

   HTTPS is enabled by default. You can also enable HTTP, SSH, and Telnet support.

3. If necessary, edit the IP Address / Netmask.
4. Click OK.