Enable workspace mode

Workspace mode can be enabled per ADOM or in all ADOMs.

After changing the workspace mode, your session will end, and you will be required to log back into the FortiManager.

To enable workspace mode on all ADOMs in the GUI:

1. Go to System Settings > Admin > Workspace.
2. Click Workspace.

   

3. Click Apply. Your session ends, and the FortiManager login screen is displayed.

To enable workspace mode on all ADOMs in the CLI:

config system global

set workspace-mode normal

end

When workspace mode is enabled, Device Manager and Policy & Objects are read-only. You must lock the ADOM, a device, or a policy package before you can make any changes.

To enable workspace mode per ADOM in the GUI:

1. Ensure ADOMs are enabled.
2. Go to System Settings > Admin > Workspace.
3. Click Per-ADOM. The Per-ADOM setting is enabled.

   

4. Click Apply. Your session ends, and the FortiManager login screen is displayed.
5. Log in to FortiManager, and go to System Settings > All ADOMS. Ensure you are in the correct ADOM.
6. Double-click an ADOM, or right-click the ADOM and select Edit. The Edit ADOM page is displayed.
7. In the Workspace Mode area, click Workspace.

   

8. Click OK. Your session ends, and the FortiManager login screen is displayed.

To enable Per-ADOM mode in the CLI:

config system global

set workspace-mode per-adom

end

After the Per-ADOM setting is enabled, you can update the workspace setting in the GUI.