config system time ntp
Use this command to configure FortiAI to synchronize its system time with a network time protocol (NTP) server.
Accurate system time is required by many features of FortiAI such as log messages and SSL-secured connections.
Syntax
config system time ntp
set ntpserver {<address_ipv4> | <fqdn_str>}
set ntpsync {enable | disable}
set syncinterval <interval_int>
end
|
Variable |
Description |
Default |
|---|---|---|
|
|
IP address or FQDN of an NTP server. You can add a maximum of ten NTP servers. FortiAI uses the first NTP server based on the selection mechanism of the NTP protocol. To locate a public NTP server, visit http://www.ntp.org/. |
|
|
|
Enable to synchronize FortiAI with an NTP server instead of manually configuring the system time. |
|
|
|
The interval in minutes between synchronizations of the system time with the NTP server. The valid range is 1 to 1440. |