config system snmp community

Use this command to configure simple network management protocol (SNMP) v1/2 settings. These commands apply only if the SNMP agent is enabled.

Syntax

config system snmp community

edit <index_int>

config host

edit <index_int>

set ip <address_ipv4>

set name <name_str>

set queryportv1 <port_int>

set queryportv2c <port_int>

set queryv1-status {enable | disable}

set queryv2c-status {enable | disable}

set status {enable | disable}

set trapevent {cpu | logdisk | datadisk | mem | system}

set trapportv1_local <port_int>

set trapportv1_remote <port_int>

set trapportv2c_local <port_int>

set trapportv2c_remote <port_int>

set trapv1_status {enable | disable}

set trapv2c_status {enable | disable}

end