Resolved issues
The following issues have been fixed in FortiSwitchOS 7.2.5. For inquiries about a particular bug, please contact Customer Service & Support.
| Bug ID | Description |
|---|---|
| 860773 | The output of the diagnose sys psu status command is wrong for the FSR-112D-POE model when both power supply units (PSUs) are connected and on. |
| 866288 | ACLs should work correctly on the FS-3032E model. |
| 878762 | A VLAN interface labeled mgmt causes the GUI to crash frequently. |
| 889987 |
When the port descriptions are too long, a “500 Internal Server Error” is reported. |
| 891323 | Going to the Router > Config > OSPF > Areas page results in an Internal Server Error. |
| 896010 | The FS-524D and FS-524D-FPOE models will assign two split ports with the same physical MAC address. |
|
896925 |
After configuring the |
|
897887 |
After enabling the blocking of intra-VLAN traffic on the VLAN, the clients cannot reach the Internet. |
| 898637 | The set poe-pre-standard-detect enable command does not work on the FS-124F-FPOE
and FS-148F-FPOE models. |
|
902062 |
After upgrading to FortiSwitchOS 7.2.2, the SFP link between the FS-124E model and the Calix E-9 System randomly turns off. |
|
902493 |
The FS-148F-FPOE and FS-148F-POE models need to provide power over Ethernet (PoE) power to Cisco phones with Key Expansion Modules (KEMs). |
|
902910 |
The 2048 key size generated certificate file shows the wrong key size in the CSR decoder. |
|
905384 |
The IGMP-snooping daemon crashes on the FS-148F model. |
|
906594 |
The GUI needs to support static IP/32. |
|
909353 |
The FS-448E, FS-448E-POE, and FS-448E-FPOE models should provide the hardware status and temperature monitoring using the SNMP OIDs. |
| 910257 | Going to System > Config > Firmware results in a “500 Internal Server Error.” |
| 917919 | The GUI produces an “Internal server error” after an administrator user that is more than 35 characters long tries to log in. |
|
918017 |
Using RSPAN on managed FSR-112D switches under FortiOS 7.0.11 causes network interruptions. |
|
921600 |
Unplugging and then plugging in a PC connected to an FS-221E-POE model causes the STP state to change. |
|
922307 |
The FN-TRAN-SFP-1BU10, FN-TRAN-SFP-1BD10, FN-TRAN-SFP-1BU40, and FN-TRAN-SFP-1BD40 transceivers need to support the |