Email alert settings
Enabling Email Alert Settings allows FortiPAM to send alert emails to administrators.
To enable Email alert setting:
-
Go to Log & Report > Email Alert Settings, and select Enable email notification.
- In the Glassbreaking Notification pane, enter the following information:
From
The email address of the sender.
To
The email address of the receiver.
Select + to add additional email addresses.
- In the General pane, enter the following information:
From
The email address of the sender.
fortipam@example.com
To
The email address of the receiver.
admin1@example.com
admin2@example.com
Select + to add additional email addresses.
Alert parameter
Select from the following two options:
Events: Alerts are sent when an event occurs, e.g., system or user events. See Events.
Severity: From the dropdown, select the minimum level of severity at which the alerts are sent.
Interval
The time interval at which the alerts are sent, in minutes (default = 5, 1- 99999).
Note: The option is only available when the Alert parameter is set as Events.
Security
Note: The pane is only available when the Alert parameter is set as Events.
Virus detected
Enable/disable sending alerts when virus detected.
Administrative
Note: The pane is only available when the Alert parameter is set as Events.
Configuration change
Enable/disable sending alerts when a configuration is changed.
Note: The option is disabled by default.
HA status change
Enable/disable sending alerts when the HA status changes.
Note: The option is disabled by default.
- Click Apply.